中空成型机

injectionmoldingmachine10008m50133.jpg

产品编号:

EMBC-6T-EX50

产品名称: 中空成型机

产品规格:

The special characters of the all electric driven blow molding machine EMBC series are as below:
a.Low noise level, machine is much quire than conventional machine while operating.
b.Less energy consumption (save electric power up to 60% compare to conventional hydraulic power model).
c.No hydraulic System maintenance is required.(all movement are driven by servo motors.)
d.Clean work area, hygiene no oil contamination to end product.(can be set production line in the clean room.)
e.Maximum precision and repeatability in every cycle.
f.High efficiency, low defect rate.
g.Easy to set-up mold.
h.Environmental and user friendly.
HIGH PRUITY
Since electric ?servo motors were introduce to the machine, driving the specialty of low noise, low inertia, precise position, were obtained to avoid leakage, permeation problem of hydraulic system. It is the most good idea for modern blow molding line.
This model of blow molding machine is suitable for medicinal, electronicshemical and food container-etc.
EASY MAINTENANCE
No management of hydraulic oil.
No periodic inspection of oil seal, piping and valve.
Only grease toggle shaft, ball screw and bearing.
ENERGY SAVING
Less electric power and cooling water consumption.
Lots of electrical-servo motor and ball screw were replaced to the conventional hydraulic system.
The power consumption was possibly lower.11 HP for 10 sec cycle include parison programmer.
HIGH PRECISION
Driving by electrical-servo motor with high speed PC controller, 0.05mm tolerance of precision can be reached.
INCREASE WELL PRODUCTION RATE
Without hydraulic problems, steady machine motion was occurred from starting. The repeating tolerance within 0.1 sec.
Smooth mechanical movement control increase strength of seam line.

Optional equipments
Visual-strip
In-mould label equipment
Trimming equipment
Auxiliary accessories
1. Air compressor
2. Mixer
3. Water chiller
4. Cooling tower
5. Auto. Loader
6. Hopper dryer
7. Proportional valve
8. Dehumidifier
9. Power crusher
10. Conveyor
11. Volumetric color dosing
12. Mold
CLOSING UNIT

Clamping force Ton 6
Maximum daylight mm 475
Minimum daylight mm 125
Maximum closing speed mm/sec 500
Platen dimensions(W*H) mm 300*350
Horizontal stroke mm 4000

EXTRUDERS
Screw Diameter mm 40 50 60 75
Screw length L/D 24 24 24 24
Maximum output in HDPE Kg/hr 35 40 85 130
Driven Motor Kw 11 19 30 45
Heating zone n 2 2 3 4

CONTINUOUS HEAD
Head sealing min diameter mm 30
Head sealing max diameter mm 120
Heating power kw 7
Heating zone n 3
Thickness controller points 100

LAY-OUT GENERAL
Average electric consumption(55%) kw 15
Pneumatic pressure bar 8
Machine width mm 1600
Machine Length mm 4100
Machine height mm 2450
Total weight Ton 5.5

中空成型机

 关于我们

公司名称:

日晃机械工业有限公司

主要产品:

电动中空成型机,中空成型机,塑料中空成型机,塑料瓶吹瓶机

地址:

台南县永康市民东路42号

电话号码:

886-6-2533648 ~9

传真:

886-6-2425890
 相关产品