產品名稱: 中空成型機

產品規格:

The special characters of the all electric driven blow molding machine EMBC series are as below:
a.Low noise level, machine is much quire than conventional machine while operating.
b.Less energy consumption (save electric power up to 60% compare to conventional hydraulic power model).
c.No hydraulic System maintenance is required.(all movement are driven by servo motors.)
d.Clean work area, hygiene no oil contamination to end product.(can be set production line in the clean room.)
e.Maximum precision and repeatability in every cycle.
f.High efficiency, low defect rate.
g.Easy to set-up mold.
h.Environmental and user friendly.
HIGH PRUITY
Since electric ?servo motors were introduce to the machine, driving the specialty of low noise, low inertia, precise position, were obtained to avoid leakage, permeation problem of hydraulic system. It is the most good idea for modern blow molding line.
This model of blow molding machine is suitable for medicinal, electronicshemical and food container-etc.
EASY MAINTENANCE
No management of hydraulic oil.
No periodic inspection of oil seal, piping and valve.
Only grease toggle shaft, ball screw and bearing.
ENERGY SAVING
Less electric power and cooling water consumption.
Lots of electrical-servo motor and ball screw were replaced to the conventional hydraulic system.
The power consumption was possibly lower.11 HP for 10 sec cycle include parison programmer.
HIGH PRECISION
Driving by electrical-servo motor with high speed PC controller, 0.05mm tolerance of precision can be reached.
INCREASE WELL PRODUCTION RATE
Without hydraulic problems, steady machine motion was occurred from starting. The repeating tolerance within 0.1 sec.
Smooth mechanical movement control increase strength of seam line.

Optional equipments
Visual-strip
In-mould label equipment
Trimming equipment
Auxiliary accessories
1. Air compressor
2. Mixer
3. Water chiller
4. Cooling tower
5. Auto. Loader
6. Hopper dryer
7. Proportional valve
8. Dehumidifier
9. Power crusher
10. Conveyor
11. Volumetric color dosing
12. Mold
CLOSING UNIT

Clamping force	Ton	6
Maximum daylight	mm	475
Minimum daylight	mm	125
Maximum closing speed	mm/sec	500
Platen dimensions(W*H)	mm	300*350
Horizontal stroke	mm	4000

EXTRUDERS

Screw Diameter	mm	40	50	60	75
Screw length	L/D	24	24	24	24
Maximum output in HDPE	Kg/hr	35	40	85	130
Driven Motor	Kw	11	19	30	45
Heating zone	n。	2	2	3	4

CONTINUOUS HEAD

Head sealing min diameter	mm	30
Head sealing max diameter	mm	120
Heating power	kw	7
Heating zone	n。	3
Thickness controller	points	100

LAY-OUT GENERAL

Average electric consumption(55%)	kw	15
Pneumatic pressure	bar	8
Machine width	mm	1600
Machine Length	mm	4100
Machine height	mm	2450
Total weight	Ton	5.5